Here is the diagram of the 4ohm wiring: Hope this helps. They can only be wired as a 1ohm load (too low for the amp) or as a 4ohm load (at reduced power). Here's the diagram: If you have the Kicker model number 06CVX124 with dual 4ohm voice coils, they cannot be wired to present a 2ohm load. Then wire both of the remaining positives and negatives together on the amp terminals (in parallel). First jumper the voice coils in series, the dotted positive (+) to the undotted negative (-) (or vice versa). Hello storres18, If you have the Kicker model number 06CVX122, with dual 2ohm voice coils, they can be connected to a mono amp at 2ohms. You splice into your speaker wires and run them into the unit, then plug the RCAs into it. A basic one like the Scosche SLC4 usually runs in the $20 range. If you have a factory stereo you won't have RCA ouputs, so you will need a line level converter. 61 Answers SOURCE: You will need the following: A power wire (preferably 4 or 8 gauge) with an inline fuse (typically 50amps) A battery terminal adapter to connect the power wire A signal wire to let the amp know when the stereo is on RCA audio cables to connect the amplifier to your stereo A ground wire for the amplifier (again 4 or 8 gauge preferred) Walmart sells a Scosche kit that has all of the wiring as well as a basic diagram for about $25, but it does not include the battery terminal adapter.The fuse holder seems to be messed up, and I had.

Visonik amplifier installation? I have a Visonik car amplifier, and it won't turn on.

Visonik vbx12a installation